Help support TMP


"Making thick spears thinner." Topic


5 Posts

All members in good standing are free to post here. Opinions expressed here are solely those of the posters, and have not been cleared with nor are they endorsed by The Miniatures Page.

In order to respect possible copyright issues, when quoting from a book or article, please quote no more than three paragraphs.

For more information, see the TMP FAQ.


Back to the 28mm Fantasy Message Board

Back to the Warhammer Message Board


Areas of Interest

Fantasy

Featured Link


Top-Rated Ruleset

Savage Worlds: Showdown


Rating: gold star gold star gold star gold star gold star gold star gold star gold star gold star 


Featured Showcase Article

Cheap Undead Dinos

Need some walking dinosaur skeletons?


Featured Workbench Article

Building a Simple Data Set for Army Builder 3

Learning how to set up a new game system for use with Army Builder, the army design software from Lone Wolf.


Current Poll


Featured Book Review


Featured Movie Review


309 hits since 18 Apr 2024
©1994-2024 Bill Armintrout
Comments or corrections?

The H Man18 Apr 2024 5:52 p.m. PST

In this pic from the latest Warhammer community TOW post, you can see the black spear looks thinner compared to the he lighter coloured spears.

Obviously thicker spears are best, as they don't break easily, but it doesn't mean they have to look thick.

picture

Personal logo Sgt Slag Supporting Member of TMP19 Apr 2024 6:14 a.m. PST

Cut off the plastic/metal/resin molded spear, flush with the figure's hand, top and bottom. Get a Pin Vise (mini hand drill, comes with mini drill bits), and drill a hole in the hand. Insert a brass metal spear, available from hobby suppliers, e-Bay, etc. Cut the spear shaft to required length, and glue into the figure's hand. Paint, and game.

Here are the spears I recently ordered. Very satisfying, very easy to use. Here is an example of a valid, extremely useful, Pin Vise.

The brass wire spears are much thinner, very stiff, and the formed tips are VERY SHARP. They just need to be cut down to the needed length (pikes, spears, javelins, etc.), and painted. Be aware that these spears pose a genuine stabbing risk to players who carelessly grab the minis on the tabletop… You have been warned. Cheers!

Col Durnford Supporting Member of TMP19 Apr 2024 7:18 a.m. PST

You can also make your own with a dremel.

Use the cutting wheel to cut to length and the same tool for file down the point.

Make one pass on each side to get the point flat and then do the same to get the point shaped.

Leon Pendraken Sponsoring Member of TMP19 Apr 2024 4:52 p.m. PST

Just in case it's of interest, we're selling wire spears and pikes now too, in 40mm/50mm/80mm/100mm options: pendraken.co.uk/weapons

The H Man20 Apr 2024 6:39 p.m. PST

Or just paint it black.

I may do a test on this at some point.

Another option is to simply trim, sand, file the spear down.

Drilling gets awfully fiddly, especially if trying to use the same spear tips, more drilling and gluing. X many figures.

I suspect painting holds the key, especially with more ornate spears and staffs.

Black is known to be slimming…

…sorry, what was I saying? Oh yes, spears.

I suspect painting it darker means edge lighting is more contrasting than on a lighter colour, so the dark spear visible is narrower. A lighter spear will look similar to the lighting on its edges, thus looking like one fat spear.

That's my take on it.

Painting on vertical lines, either wood grain or highlights, may also help. As vertical stripes are also slimming…

Sorry - only verified members can post on the forums.